News

The profile automatic film sticking machine is the 1 commonly used attachment equipment in the packaging attachment industry at present. It has a high degree of automation, so it is also called the full profile automatic film sticking machine. Since it was put into the market, this model has been well received by major production enterprises. After nearly 20 years of continuous updating and upgrading, the current profile automatic film sticking machine has also been 1 greatly improved and improved, looking at the current profile automatic laminating machine market, fish and dragons mixed, then how to buy a suitable for their own production of equipment.

Before purchasing an automatic profile laminating machine, we need to position our products in the market, take into account the characteristics of the attached products, the automatic profile laminating machine and the effect of the attachment. The automatic profile laminating machine is divided into three attachment methods.

1. Scraping method, product precision requirements are not high, no bubble requirements, high capacity requirements of the product can choose the scraping method attached.

2. Sticking method, the product has no bubble requirements, and the product with high precision and productivity requirements can be attached by suction method.

3. Rolling and pasting method. Products with bubble requirements and high precision and productivity requirements can be pasted by rolling and pasting method.

Budget for equipment costs and daily working capacity.

An automatic profile laminating machine can not only improve the working capacity of the enterprise, but also save a lot of labor cost for the enterprise. Although the degree of automation has been raised, for some small processing enterprises, if they want to upgrade from semi-automatic equipment to fully automatic equipment, they need to make a specific estimate of the daily working capacity and equipment procurement cost. The cost of automated equipment is higher than that of semi-automatic equipment, we should make a reasonable budget and spend every penny on the cutting edge in order to bring greater profits to the enterprise.

Profile automatic film machine is prone to what problems.

The film follows the backing paper: the whole roll of film is not fixed, adjust the pulling force of the tension spring, adjust the length of the film, and the speed of the film-out motor does not match the speed of the film-sticking motor.

During the film sticking process, the film got stuck and the mold release motor triggered an alarm: the fiber optic detection head was not shining on the tracking hole, the amplifier was not set properly, and the rolling film pressure shaft was pressed down too much. Adjust the height of the pressure shaft, and the film tension was too high. Relax the tension spring tension.

After the film is applied, there are many bubbles: the height of the label removal plate is too low, adjust the height of the peeling plate, and the height of the rolling roller shaft is too high, adjust the height of the roller shaft.

Wrinkles behind the film: The speed of the film release motor is too fast. Adjust the fine adjustment value of the film pulling, adjust the height of the peeling plate, adjust the distance between the film rolling shaft and the peeling plate, and use the automatic film sticking machine for profile materials.